mikeinwood20
05-12-2008, 07:57 AM
Hi,
I've had my T-28 for about 4 months now but I've just noticed a problem. When I'm flying on full rates the elevator trim keeps changing. For example, If I pull in up elevator to go round a loop, when I release the stick again the model continues to climb slightly and when I push in a small amount of down elevator the elevator sticks in the slight down position, its like the elevator won't centre properly. At first I though my tailplane may have been loose, but now I'm not sure if its a servo problem. Any ideas?
Mike Inwood
I've had my T-28 for about 4 months now but I've just noticed a problem. When I'm flying on full rates the elevator trim keeps changing. For example, If I pull in up elevator to go round a loop, when I release the stick again the model continues to climb slightly and when I push in a small amount of down elevator the elevator sticks in the slight down position, its like the elevator won't centre properly. At first I though my tailplane may have been loose, but now I'm not sure if its a servo problem. Any ideas?
Mike Inwood