Advice & Sales: 0845 872 5390 |
|
#31
03-24-2010, 01:57 PM
|
|||
|
|||
I overtightened an e-flite prop adapter once, had to cut it in the end to get the prop off....the threads aren't the best!
__________________
Hangar =E-Flite Blade mSR + Blade 400, RC Factory Yak 55, 3DHS 51" AJ Slick, 3DHS 70" AJ Slick a 3DHS 87" Extra 300 SHP, 3DHS 68", a 57" 3DHS Extra 330SC, 65" 3DHS Vyper, 62" 3DHS Osiris, UM 4-Site oh and a FF MX2  ....addicted mmm yup!!
|
|
#32
03-24-2010, 08:45 PM
|
|||
|
|||
|
I don't think I over tightened it mate, the prop and the washer I added haven't got indentations to increase grip.
|
|
#33
03-27-2010, 07:52 PM
|
|||
|
|||
|
Well the saga continues: Hooked up the watt meter for both 2 and 3 bladers, around 285w 25a on the 3 blader, on a full 30c batt. 324w 29a on the 2 blader. Whole spinner unit flew off when I was testing the 2 blader
 , I needed to add another washer to get the adapter to grip fully. Not too sure if this esc would last long with the 2 blader on, it got pretty hot, even with full air flow over it. So unless I upgrade the esc, I guess I'll stick with the 3 blader  Damned plane!!!! I really do wish I'd bought the Stang instead.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
